Summary #
This guide covers the physical installation, hardware connections, and initial software configuration for the ProfiLux 4 Series and ProfiLux Mini / Light WiFi. The exact ports and accessories available vary by model — refer to the manual for your specific device.
For device-specific instruction manuals, see the Downloads section below.
Applies to #
- ProfiLux 4 Series (incl. Industrial Line / IL)
- ProfiLux Mini / Light (WiFi versions only)
- Software:
- GHL Connect (App, Webinterface, myGHL)
- GHL Control Center
Installation #
Mounting #
Mount the ProfiLux in a water-protected area, away from splashing water or high humidity. Ensure the device cannot fall into the water during installation or normal use. The ProfiLux Mini / Light WiFi can be wall-mounted using the keyholes on the rear panel.
Hardware Connections #
Connect the ProfiLux to a power outlet using the supplied 12V DC power adapter. Then connect sensors, Powerbars, lighting, pumps, and other devices to the appropriate ports according to the manual for your device.
A temperature sensor is included in most sets — connect it to the temperature sensor port. For sets that include additional accessories such as a GHL Control Pad, PAB Powerbar, or further sensors, connect these as well.
See the relevant articles in the Next Steps section for configuration of each connected device.
ProfiLux Mini / Light WiFi — Multifunction port: Level sensors, Mitras Lightbar / Slimline, and the automatic feeder all share the black Multifunction port. A splitter cable is required when connecting multiple devices to this port.
Connecting to GHL Connect or GHL Control Center #
After powering on the device, connect to it via GHL Connect or GHL Control Center to proceed with the initial configuration.
On first startup, the ProfiLux 4 and ProfiLux Mini / Light WiFi create a WiFi access point — connect to it using GHL Connect to configure a permanent network connection. Alternatively, connect via USB. See the Network (LAN & WiFi) – Setup Guide and GHL Connect & GHL Control Center – Installation & Setup for details.
Initial Settings #
Open General to configure the following device-wide settings:
- Language: Sets the language shown on the device’s own display.
- Time & Date: Set the correct time and date — required for all schedules and simulations. Enable NTP for automatic synchronization. Set the correct timezone and enable daylight saving time adjustment if needed.
- Display settings: See the Display – Configuration Guide.
- Key sound (ProfiLux 4 only): Enable or disable the sound when touching the capacitive keys.
- GHL Logo Illumination (ProfiLux 4 only): Configure brightness and mode of the GHL logo LED. See the GHL Logo – Status Indicator for color and blink code reference.
- Alarm buzzer (ProfiLux 4 and ProfiLux Mini only): Configure when the buzzer sounds — Off, Always, or At set time.
- PIN protection (optional): Set a PIN to restrict software access. In GHL Connect: General page. In GHL Control Center: Extras in the top menu bar → Security → PIN.
Next Steps #
Software & Connectivity
- Network (LAN & WiFi) – Setup Guide — connect the ProfiLux to your network and myGHL
Hardware (ProfiLux 4)
- PAB – Connection & Configuration Guide — assign and configure PAB devices
- Expansion Cards – Setup Guide — install and configure expansion cards
- GHL Control Pad – Setup Guide — set up the GHL Control Pad
Sensors & Switch Outputs
- Sensor Configuration Guide — configure connected sensors
- Powerbar & PowerHub – Setup Guide — set up and configure Powerbars
Lighting
- Mitras Lightbar & Slimline – Setup Guide — set up Mitras Lightbar units
- Mitras LX6 & LX7 – Setup Guide — set up and configure Mitras LX fixtures